Op Amp Lab

In this lab, a 741 op-amp was used to create inverting amplifier circuit under the pretense of creating a signal conditioning circuit for a sensor.

A voltage divider was devised to get a voltage of one volt for the V_IN and mimic a sensor's output.
The following data was collected on the components we used.

 Above is the layout of our circuits.

I_V1 = 8.95 mA
I_V2 = 0.95 mA
Because these aren't equal to each other, we couldn't go on to the last page of the lab because he lab was written in anticipation of each group getting a 3rd voltage source, but only 2 were available for each.